Subject	Re: How do you set the crank balancer pulley to "0"?
Posted by	xteam300tt on November 09, 2009 at 10:04 PM
	This message has been viewed 192 times.
In Reply To	How do you set the crank balancer pulley to "0"? posted by Zarcasm(Hfd, CT) on November 09, 2009 at 09:26 PM
Message	turn the crank using a 27mm socket until the mark on the crank pulley lines up to the "0" on the measure indicator on the lower timing cover . dont linr them up while looking straight down from the middle of the engine , you need to tilt your head to the left 15 to 20 degrees to get an accurate alignment of the marks and not be fooled by divergency
Follow Ups	Post Timing Belt Change-Loss of Power? - Nikknakz 18:55:25 11/08/09 Pull back the timing covers and doublecheck everything - twinturbineZ 19:23:45 11/08/09 Re: Post Timing Belt Change-Loss of Power? - WazTTed 20:45:15 11/08/09 Would assume you've verified the engine timing - jzack 22:22:27 11/08/09 Re: Post Timing Belt Change-Loss of Power? - ZTurboFan 10:15:04 11/09/09 Re: Re: Post Timing Belt Change-Loss of Power? - Nikknakz 19:39:55 11/09/09 You can get an idea if the belt is off - canyoncarver 20:13:54 11/09/09 How do you set the crank balancer pulley to "0"? - Zarcasm(Hfd, CT) 21:26:08 11/09/09 Re: How do you set the crank balancer pulley to "0"? - xteam300tt 22:04:10 11/09/09 Re: Re: How do you set the crank balancer pulley to "0"? - ZTurboFan 00:28:42 11/10/09 A properly installed timing belt can appear to be off - canyoncarver 06:51:56 11/10/09 Re: A properly installed timing belt can appear to be off - ZTurboFan 10:42:11 11/10/09 Re: A properly installed timing belt can appear to be off (n/m) - Nikknakz 22:22:26 11/10/09 Re: A properly installed timing belt can appear to be off - Nikknakz 22:27:20 11/10/09 Yes, being off 1 tooth can affect performance. - canyoncarver 06:15:53 11/11/09 Thanks folks (n/m) - Zarcasm(Hfd, CT) 22:26:02 11/10/09 sounds like Zarcasm (n/m) - canyoncarver 06:43:23 11/10/09
Post a Followup	You cannot reply to this message because you are not logged in.