Subject	It is a EVAP canister purge control solenoid valve
Posted by	AndrewZ32 (MO) on October 26, 2009 at 10:53 PM
	This message has been viewed 2399 times.
In Reply To	Need a quick answer about vacuum lines after EBC install posted by MAD_96TT(ATX) on October 26, 2009 at 09:31 PM
Message	It is part of the OBDII emissions that are only on 96's The hose that goes to that nipple should be t'd off the boost solenoid and also a hose should go to the turbo intake pipe. Shown in the diagram below
Follow Ups	Need a quick answer about vacuum lines after EBC install - MAD_96TT(ATX) 21:31:28 10/26/09 That's the PRVR solenoid. I know theres a vacuum line that - Eric(NJ) 21:38:53 10/26/09 Your thinking of the one below the MC. This one sits tucked - MAD_96TT(ATX) 21:58:48 10/26/09 wtf. none of that rings a bell. (n/m) - ali300zx 22:14:11 10/26/09 '96 thing maybe? (n/m) - MAD_96TT(ATX) 22:20:21 10/26/09 Yes, it's a '96 thing. (n/m) - Woody75 (Denver) 10:46:48 10/27/09 Have you seen this in the FAQ section? - ZXRider(SoCal) 21:50:38 10/26/09 It is a EVAP canister purge control solenoid valve - AndrewZ32 (MO) 22:53:12 10/26/09 thanks! So, I need to tee off of the actuator line twice. - MAD_96TT(ATX) 23:25:47 10/26/09 No just run a line from the EVAP solenoid to the intake pipe - AndrewZ32 (MO) 23:51:48 10/26/09 Thanks for the help. I've got it all back together and it is - MAD_96TT(ATX) 15:23:08 10/29/09
Post a Followup	You cannot reply to this message because you are not logged in.