Subject	That's the PRVR solenoid. I know theres a vacuum line that
Posted by	Eric(NJ) on October 26, 2009 at 9:38 PM
	This message has been viewed 1308 times.
In Reply To	Need a quick answer about vacuum lines after EBC install posted by MAD_96TT(ATX) on October 26, 2009 at 09:31 PM
Message	runs from the driver's side of the plenum from one of the brass fittings to the solenoid but I don't know if it connects to that nipple. The other lines should run under the clutch master cylinder and disappear into the fender. If you want you can actually delete that solenoid and the associated lines to clean up some. later, eric
Follow Ups	Need a quick answer about vacuum lines after EBC install - MAD_96TT(ATX) 21:31:28 10/26/09 That's the PRVR solenoid. I know theres a vacuum line that - Eric(NJ) 21:38:53 10/26/09 Your thinking of the one below the MC. This one sits tucked - MAD_96TT(ATX) 21:58:48 10/26/09 wtf. none of that rings a bell. (n/m) - ali300zx 22:14:11 10/26/09 '96 thing maybe? (n/m) - MAD_96TT(ATX) 22:20:21 10/26/09 Yes, it's a '96 thing. (n/m) - Woody75 (Denver) 10:46:48 10/27/09 Have you seen this in the FAQ section? - ZXRider(SoCal) 21:50:38 10/26/09 It is a EVAP canister purge control solenoid valve - AndrewZ32 (MO) 22:53:12 10/26/09 thanks! So, I need to tee off of the actuator line twice. - MAD_96TT(ATX) 23:25:47 10/26/09 No just run a line from the EVAP solenoid to the intake pipe - AndrewZ32 (MO) 23:51:48 10/26/09 Thanks for the help. I've got it all back together and it is - MAD_96TT(ATX) 15:23:08 10/29/09
Post a Followup	You cannot reply to this message because you are not logged in.