Subject	In addition; I tested the voltage using a multimeter at both
Posted by	ZEVAN (Ca) on June 27, 2009 at 4:14 PM
	This message has been viewed 92 times.
In Reply To	Dual Maf question... posted by ZEVAN (Ca) on June 27, 2009 at 02:09 PM
Message	Inputs and at the output. The voltage I measured at the inputs matched what the neo was saying however I measured 1.45v at the output which is closer to what I was expecting but not what the neo is saying. I went for a short drive and under load I found that the two mafs outputted almost identicle voltages. Now I suspect the mafs are both ok...driver side maf must be pulling more air at idle due to the idle air control. I don't plan on driving it again until I get a wideband because I fear the neo may cause it to run lean with those voltage levels. If anyone has this setup i'd be very interested to know if your output voltage is actually the sum of the two input voltages. Formerly: Evan3zx(ca) Xbox live GT: kidding Me 1991 CRP TT 1993 Pearl White NA
Follow Ups	Dual Maf question... - ZEVAN (Ca) 14:09:46 06/27/09 In addition; I tested the voltage using a multimeter at both - ZEVAN (Ca) 16:14:19 06/27/09 Re: Dual Maf question... - Dane (Houston) 17:48:22 06/27/09 Sweet, I was hoping to hear from you. If I understand - ZEVAN (Ca) 20:30:27 06/27/09 Re: Sweet, I was hoping to hear from you. If I understand - Dane (Houston) 09:47:44 06/28/09 I haven't been using it to tune since I don't have a - ZEVAN (Ca) 09:54:22 06/28/09 Re: I haven't been using it to tune since I don't have a - Dane (Houston) 10:48:38 06/28/09 Yes, normal (n/m) - zgene4 21:59:39 06/27/09
Post a Followup	You cannot reply to this message because you are not logged in.