Subject	Dual Maf question...
Posted by	ZEVAN (Ca) on June 27, 2009 at 2:09 PM
	This message has been viewed 136 times.
Message	I just installed a dual maf/dual intake with a Apexi Neo. I have a single pop chip so I am using the add function. My settings are: Hot wire, in:2 out:2, twin:add. When I am at idle input 1(driver side maf) shows about 1.15v while input 2(pass side maf) shows about 0.6v. Output is at about 1.18v. Is it normal for the passenger side to be so much lower? And why is the output not the sum of the two inputs? Formerly: Evan3zx(ca) Xbox live GT: kidding Me 1991 CRP TT 1993 Pearl White NA
Follow Ups	Dual Maf question... - ZEVAN (Ca) 14:09:46 06/27/09 In addition; I tested the voltage using a multimeter at both - ZEVAN (Ca) 16:14:19 06/27/09 Re: Dual Maf question... - Dane (Houston) 17:48:22 06/27/09 Sweet, I was hoping to hear from you. If I understand - ZEVAN (Ca) 20:30:27 06/27/09 Re: Sweet, I was hoping to hear from you. If I understand - Dane (Houston) 09:47:44 06/28/09 I haven't been using it to tune since I don't have a - ZEVAN (Ca) 09:54:22 06/28/09 Re: I haven't been using it to tune since I don't have a - Dane (Houston) 10:48:38 06/28/09 Yes, normal (n/m) - zgene4 21:59:39 06/27/09
Post a Followup	You cannot reply to this message because you are not logged in.