Subject	I put dielectric grease in my coolant temperature sensor and
Posted by	flashstar on April 18, 2009 at 12:39 PM
	This message has been viewed 294 times.
In Reply To	Pack it full of dielectric grease and it'll stay put, posted by BobbyT on April 18, 2009 at 02:07 AM
Message	the sand built up in the connector turned to paste... = No start.
Follow Ups	Fixed my no starting issue. - Woody75 (Denver) 22:25:50 04/16/09 As frustrating as it has been - it's also a relief after - jzack 22:44:35 04/16/09 My interior/dash is all torn apart :( - Woody75 (Denver) 08:20:01 04/17/09 That's the alt-trans harness, but what's that connector? (n/m) - BigTDogg (MA) 23:04:02 04/16/09 It's the single signal wire off/for the starter. (n/m) - Woody75 (Denver) 08:17:11 04/17/09 picture shows . . . ? (n/m) - robo (sebring1970) 23:22:08 04/16/09 a disconnected connector? (n/m) - KasbeKZ 23:58:22 04/16/09 the one on the right (n/m) - BigTDogg (MA) 00:03:22 04/17/09 An insane lack of dirt :-) (n/m) - Ted (92TT) 00:30:55 04/18/09 Good to hear Tim! (n/m) - Piranha(PHX) 00:57:55 04/17/09 These "pop off" all the time, if they were nvr popped on :) (n/m) - Nick(CT) 08:21:02 04/17/09 Brand new harness, been driving the car for months. - Woody75 (Denver) 08:54:32 04/17/09 might have been seated, just not clipped. (n/m) - ZiNnYc 10:16:44 04/17/09 True, but I would think it would pop off when driving though - Woody75 (Denver) 12:23:18 04/17/09 Maybe popped off when driving - Mickie 16:16:32 04/17/09 "Sh!t & I bought a shifter from a guy with inexplicable - Nick(CT) 10:54:24 04/17/09 Pack it full of dielectric grease and it'll stay put, - BobbyT 02:07:52 04/18/09 I put dielectric grease in my coolant temperature sensor and - flashstar 12:39:35 04/18/09 interesting (n/m) - canyoncarver 08:52:26 04/17/09 Good to hear (n/m) - yobobrox 11:21:36 04/17/09 Re: Fixed my no starting issue. - Stpdfast Z 22:09:50 04/18/09 I wasn't asking what it was but thanks though. (n/m) - Woody75 (Denver) 11:36:54 04/19/09
Post a Followup	You cannot reply to this message because you are not logged in.