Subject	Machined lower plenum for 95+ style fuel system
Posted by	J-Mart on October 13, 2008 at 5:37 PM
	This message has been viewed 214 times.
Message	I have a 93 lower plenum that I need to machine to accept the 95+ 300 degree rails I got. Who has had it done? By what shop? Is there anything I should keep in mind or be aware of? I have access to a full machine shop and knowledgeable machinists, but I don't know what needs done exactly. I would do it myself if I could justify the time/tool costs (if i need to buy a mill bit, etc). Thanks. Jared 1994 Twin Turbo
Follow Ups	Machined lower plenum for 95+ style fuel system - J-Mart 17:37:30 10/13/08 Just send it to JWT, but smooth out the sharp edges - na300zx (OH) 17:46:33 10/13/08 if you have the 300degree fuel rails - Ahmed (Chicago) 20:20:21 10/13/08 I got a deal on +95 300 degree rails - J-Mart 17:38:37 10/14/08 Since you have a 93 then just get the 300 degree rails >> - ZUL8TR 08:44:45 10/14/08 Have JWT mill the plenum and use the support spacers I sell (n/m) - Bernie (NoVA) 12:58:14 10/14/08
Post a Followup	You cannot reply to this message because you are not logged in.