Subject	that's pretty much what I did
Posted by	spyhunterTT(nj) on August 24, 2008 at 7:03 AM
	This message has been viewed 1132 times.
In Reply To	JDM Power Folding Mirror Conversion. (Long!) posted by DVDBURN (MD) on August 24, 2008 at 01:47 AM
Message	Good job on the writeup though. I'm pretty sure I used the all the JDM parts except the glass and glass mounts. I also had to run additional wires for the folding motor. I trick I used is that for BOSE cars that have since replaced the amps/speakers in the doors, there is an additional set of wires in that region that you can use for the amp. The other end of the door harness just needs to be cut and spliced. The good part about this is that you don't have to fish wires through the door harness. Alex
Follow Ups	JDM Power Folding Mirror Conversion. (Long!) - DVDBURN (MD) 01:47:18 08/24/08 Re: JDM Power Folding Mirror Conversion. (Long!) - Stadsport 02:00:19 08/24/08 Re: JDM Power Folding Mirror Conversion. (Long!) - toykoz32 02:20:53 08/24/08 Thanks Gary, I bookmarked it. I have a set of mirrors on - dregos 02:52:31 08/24/08 Wonderful write-up Gary! I have voted to FAQ this and - 94Z32XTT 03:43:05 08/24/08 What did you use for a heated mirror switch? - TriniTT 04:16:47 08/24/08 that's pretty much what I did - spyhunterTT(nj) 07:03:31 08/24/08 very nice Gary! - KongZTT GT28RS in TX 8/28-9/4 10:08:32 08/24/08 Very Thorough - Drk93TT 10:11:54 08/24/08 Great job! (n/m) - SeedyROM 17:07:14 08/24/08 Thanks everybody! (n/m) - DVDBURN (MD) 18:12:07 08/24/08 So does it end up at A-spec viewing angle or not? - Ted (92TT) 18:52:21 08/24/08 Basically yes. You have no problem at driver side. - DVDBURN (MD) 19:08:03 08/24/08
Post a Followup	You cannot reply to this message because you are not logged in.