Subject	need to run a compression check at a minimum
Posted by	aliaZ on July 28, 2008 at 5:05 PM
	This message has been viewed 79 times.
In Reply To	Re: have you checked compression? posted by Driggers on July 28, 2008 at 03:19 PM
Message	to determine where the problem is. I bet it isn't your valve seals. Oil in the IC piping would indicate a turbo problem. The fact that you are blowing out your dipstick indicates a possible piston ring problem or PCV problem
Follow Ups	Valve seals? - Driggers 09:35:59 07/28/08 Nope! If you are blowing the dipstick out, it almost - kkrofft (OH) 12:50:03 07/28/08 Re: Nope! If you are blowing the dipstick out, it almost - Driggers 15:15:33 07/28/08 Piston rings require a complete teardown. No point - kkrofft (OH) 19:14:08 07/28/08 have you checked compression? - aliaZ 12:50:49 07/28/08 Re: have you checked compression? - Driggers 15:19:49 07/28/08 need to run a compression check at a minimum - aliaZ 17:05:50 07/28/08 Re: need to run a compression check at a minimum - Driggers 17:31:58 07/28/08 I wouldn't rule out the turbos just yet - aliaZ 09:49:32 07/29/08 Start cheap - 300ZMang 20:51:33 07/28/08
Post a Followup	You cannot reply to this message because you are not logged in.