Subject	Re: head removal
Posted by	spdrmn on July 26, 2008 at 2:10 PM
	This message has been viewed 164 times.
In Reply To	head removal posted by spdrmn on July 26, 2008 at 12:01 AM
Message	If fuel was being dumped straight into two of the cylinders, would that blow out the head gasket, and also would that be a reason that fuel would end up in the upper plenum? I just discovered that two of my injectors(both on the problem side) weren't seated into their lower rubber washer. "Face it, you just can't beat stupid." "Never underestimate the power of stupid people in large groups"
Follow Ups	head removal - spdrmn 00:01:31 07/26/08 Yes. - Waggz 00:11:13 07/26/08 Re: Yes. - spdrmn 00:24:58 07/26/08 Probably due to improper torquing procedure. - Waggz 00:33:56 07/26/08 Don't unbolt the turbo from the manifold - awesom-o 00:51:26 07/26/08 Is that easier? - Waggz 01:01:55 07/26/08 Re: Is that easier? - awesom-o 01:35:33 07/26/08 How tight of a fit? - Waggz 02:20:29 07/26/08 larger upgraded turbo's wont make much of a difference (n/m) - 550HPTT 05:59:25 07/26/08 ^^^^^ He's right, it's basically the same - awesom-o 07:23:18 07/26/08 that's good info. thanks (n/m) - won4all 18:42:46 07/26/08 turning those head bolts is a BITCH (n/m) - amp300zx 00:49:52 07/26/08 If you're asking it's probably way over your head. - apudapus 04:13:07 07/26/08 are you sure your head gasket is leaking? - aliaZ 07:21:23 07/26/08 true... true (n/m) - 550HPTT 09:44:39 07/26/08 Re: are you sure your head gasket is leaking? - spdrmn 10:45:34 07/26/08 Re: head removal - spdrmn 14:10:41 07/26/08
Post a Followup	You cannot reply to this message because you are not logged in.