Subject	A good machine shop will utilize a bath that they
Posted by	Milo (SATX) on July 25, 2008 at 4:34 PM
	This message has been viewed 113 times.
In Reply To	Flushing coolant passages on a used motor outside of the car posted by MixManMash on July 25, 2008 at 02:27 PM
Message	normally subside the blocks into to degrease it. Disassembly is done first to prevent any damage to internal parts. That is the only safe way that I would recomment doing that. Just my $.02. Note that you can also get the cast flash out at the same time. Just throwing that out there also.
Follow Ups	Flushing coolant passages on a used motor outside of the car - MixManMash 14:27:17 07/25/08 A good machine shop will utilize a bath that they - Milo (SATX) 16:34:41 07/25/08 Yeah, I wasn't planning on going that far with this used - MixManMash 17:05:18 07/25/08 It is called hot tanking. (n/m) - Fast300 04:55:49 07/26/08 Thank you sir. I knew there was a term for it. (n/m) - Milo (SATX) 12:01:16 07/28/08 i am in the same position - Wingzerro93 00:45:55 07/26/08
Post a Followup	You cannot reply to this message because you are not logged in.