Subject	look at the gap between the tranny and engine on the top and
Posted by	pearlyellowtt on July 22, 2008 at 8:29 PM
	This message has been viewed 91 times.
In Reply To	transmission problem posted by spdrmn on July 22, 2008 at 08:13 PM
Message	bottom and try to make them as close to each other as possible. i had that problem for about an hour intil i figured out that even the slightest difference and it wont slide into to the pilot bushing. use two of the same size thickness parts like wrenches it carboard to align it
Follow Ups	transmission problem - spdrmn 20:13:08 07/22/08 I hate to be one of "those people" but - 600ZXR 20:22:17 07/22/08 hmmm.....how is it that i put and intead of an? (n/m) - 600ZXR 20:24:12 07/22/08 This should be in the tech section..I also seached the FAQ - dswtflip4u 20:30:27 07/22/08 I tried that method and it's okay but - en5 20:45:44 07/22/08 It worked like a champ for me (n/m) - spicyZ 09:38:57 07/23/08 look at the gap between the tranny and engine on the top and - pearlyellowtt 20:29:27 07/22/08 You have to put a board under the crank pulley.... - Multi_Read (MO) 20:30:35 07/22/08
Post a Followup	You cannot reply to this message because you are not logged in.