Subject	Can't help with ZEM specific?s but the best way to set the
Posted by	kkrofft (OH) on July 16, 2008 at 6:53 AM
	This message has been viewed 129 times.
In Reply To	Working with the Zemulator posted by MeatMan on July 16, 2008 at 01:13 AM
Message	K value is to create a map with all zeros. Base is 14.7:1 and map numbers are offsets from base so zeros mean 14.7. Check AFR with a wideband at idle and through the revs to around 2500. Hold steady every few hundred RPM. Adjust K until you get as close to 14.7 as you can across the board. You be able to set it exactly but you can get it so the range is close like 14.6 to 14.8 or better. Then tweek latency to get a good smooth idle. KKrofft
Follow Ups	Working with the Zemulator - MeatMan 01:13:33 07/16/08 Can't help with ZEM specific?s but the best way to set the - kkrofft (OH) 06:53:56 07/16/08 410 is WAY off. - AntiHero 08:16:46 07/16/08 See now I am a little confused here. - MeatMan 09:04:48 07/16/08 post up the values that ash has for single pop - AntiHero 09:18:30 07/16/08 single pop values - MeatMan 19:44:26 07/16/08 honestly i have no idea what hes doing here. - AntiHero 08:47:09 07/17/08 So where did you get the calculation from? Just curious. (n/m) - MeatMan 09:06:15 07/17/08 I can repost the info, but thats straight from original docs - AntiHero 09:13:16 07/17/08 I'd start with 390. Try asking SZ. (n/m) - Devi13 15:16:35 07/16/08 care to explain the number? (n/m) - AntiHero 16:01:12 07/16/08 Re: I'd start with 390. Try asking SZ. - MeatMan 19:44:56 07/16/08 I use 309 on my 740 DI single MAF. JWT uses 323. - Devi13 13:08:31 07/17/08 Inside... - Dark Diver 06:20:11 07/20/08
Post a Followup	You cannot reply to this message because you are not logged in.