Subject	two sockets and a hammer = piece of cake
Posted by	AntiHero on July 15, 2008 at 1:05 PM
	This message has been viewed 102 times.
In Reply To	or you can use a socket that will fit on the pintle side and posted by LITTLEZ(KY) on July 14, 2008 at 09:53 PM
Message	Put a deep 10 mill socket the bottom of the injector through the rail. put a socket or large wrench resting on the fuel rail. on top. tap it with a hammer. pop. Antihero These 2530's ain't half bad ;)
Follow Ups	Changed a engine out & had an injector issue. Can't get it - TyreeZtt (SeKy) 13:09:57 07/14/08 just keep twisting it back and forth with the vice grips - AntiHero 16:04:25 07/14/08 Re: Changed a engine out & had an injector issue. Can't get it - allablur 16:11:24 07/14/08 or you can use a socket that will fit on the pintle side and - LITTLEZ(KY) 21:53:35 07/14/08 two sockets and a hammer = piece of cake - AntiHero 13:05:05 07/15/08 i actually used a small crowbar (n/m) - fanta-z 02:23:25 07/15/08
Post a Followup	You cannot reply to this message because you are not logged in.