Subject	it wont. you can send an old lower manifold to get machined
Posted by	AntiHero on July 14, 2008 at 10:37 PM
	This message has been viewed 117 times.
In Reply To	Re: you cant use a new style rail on an old lower manifold posted by D.Lea on July 14, 2008 at 08:03 PM
Message	JWT or Z1 can machine an old style lower manifold to fit the new style fuel rail and injectors. its not a bad way to go, except pulling the lower manifold is a pain in the neck Antihero These 2530's ain't half bad ;)
Follow Ups	a slight knock every now and then and runs extremely rough - D.Lea 16:16:15 07/13/08 generally i would say vacuum leak on the idle issue but the - pearlyellowtt 21:29:05 07/13/08 If it's a new style lower plenum it does not line up 100% - Woody75 (Denver) 22:00:07 07/13/08 Re: If it's a new style lower plenum it does not line up 100% - D.Lea 21:24:19 07/14/08 you cant use a new style rail on an old lower manifold (n/m) - AntiHero 16:05:33 07/14/08 Re: you cant use a new style rail on an old lower manifold - D.Lea 20:03:48 07/14/08 it wont. you can send an old lower manifold to get machined - AntiHero 22:37:29 07/14/08
Post a Followup	You cannot reply to this message because you are not logged in.