Subject	Ok my follow-up was going to be about spot welds
Posted by	BobbyT on July 13, 2008 at 8:40 PM
	This message has been viewed 128 times.
In Reply To	Yes sir it is posted by collegeboy on July 13, 2008 at 08:31 PM
Message	Shouldn't be a problem if it's just tacked in place like those stupid brackets blocking the struts bars. Will it either fit back tightly enough or is it supported beneath on that side such that when I put it back it'll hold the battery fine? Not sure how things are laid out underneath, so I dunno if it'll kinda wedge back in there or if the shape of the body will hold it, versus that side wanting to bend down from the weight, end up squashing the alarm horn, etc.
Follow Ups	Is the battery tray WELDED in place?! - BobbyT 19:41:45 07/13/08 Yes sir it is - collegeboy 20:31:03 07/13/08 Ok my follow-up was going to be about spot welds - BobbyT 20:40:10 07/13/08 I removed mine a while back - collegeboy 20:44:30 07/13/08 I used 2 small bolts where the spot welds were. - Woody75 (Denver) 22:29:08 07/13/08 How did you remove it? - BobbyT 22:46:43 07/13/08 Drill out the spot welds. (n/m) - Woody75 (Denver) 23:33:41 07/13/08 Ew, don't like that answer. Anything I could hit? - BobbyT 00:08:45 07/14/08 Take off the inner fender liner and you can see behind it. - Woody75 (Denver) 10:14:47 07/14/08 Dunno, but I know you can buy an OEM replacement (n/m) - zgene4 20:31:32 07/13/08
Post a Followup	You cannot reply to this message because you are not logged in.