Subject	does the rotor fit tight over the wheel studs?
Posted by	Dane (Houston) on July 13, 2008 at 12:43 PM
	This message has been viewed 107 times.
In Reply To	350z brake upgrade clicking noise continues... posted by enthuZiast on July 13, 2008 at 12:03 AM
Message	sometimes with an aftermarket rotor, the holes for the wheels studs are too loose allowing the rotor to very slightly rotate. also check brake pad shims try with and without the pad shims Formerly SpecNATT (Houston)
Follow Ups	350z brake upgrade clicking noise continues... - enthuZiast 00:03:56 07/13/08 Maybe that rotor is warped and only hits the pads - 300ZMang 03:05:10 07/13/08 Re: Maybe that rotor is warped and only hits the pads - enthuZiast 03:39:45 07/13/08 I had the same exact problem you are - ZXRider(SoCal) 12:01:38 07/13/08 does the rotor fit tight over the wheel studs? - Dane (Houston) 12:43:57 07/13/08 Re: does the rotor fit tight over the wheel studs? - enthuZiast 13:46:42 07/13/08
Post a Followup	You cannot reply to this message because you are not logged in.