Subject	No offence taken, but I do not have the injectors...
Posted by	Tibby on July 11, 2008 at 5:42 PM
	This message has been viewed 125 times.
In Reply To	I understand where you are coming from about saving $$$ posted by nonstopna on July 11, 2008 at 03:56 PM
Message	Normally I measure things up myself but I do not have the injectors to get the measurements from. I was just hoping to get started early while the mills are free so I don't get held up later.
Follow Ups	Required machining for lower plenum? - Tibby 21:13:01 07/10/08 Re: Required machining for lower plenum? - awesom-o 21:16:53 07/10/08 I'd get the 300 degree fuel rails instead - aliaZ 22:48:35 07/10/08 I have the 95 rails already. - Tibby 08:58:20 07/11/08 To combat that, when I did my buildup, I made sure - pcproa 10:19:38 07/11/08 JWT will do it as a service for $100 plus postage. (n/m) - Bernie (NoVA) 01:39:53 07/11/08 That is $100 + postage more then it would cost me to do it - Tibby 09:04:22 07/11/08 I understand where you are coming from about saving $$$ - nonstopna 15:56:46 07/11/08 No offence taken, but I do not have the injectors... - Tibby 17:42:10 07/11/08 You don't need the injectors - you need the fuel rail. That' - Bernie (NoVA) 06:38:38 07/16/08
Post a Followup	You cannot reply to this message because you are not logged in.