Subject	tech for replacing clutch master
Posted by	WazTTed on July 11, 2008 at 7:54 AM
	This message has been viewed 146 times.
Message	is there a tech article with pics showing how 2 replace a clutch master cylinder. there are quite a few posts but no pics :( .. is it a simple unbolt . and replace job? ive heard u must bleed the master TONS aswell.. thanks ppz
Follow Ups	tech for replacing clutch master - WazTTed 07:54:13 07/11/08 Yeah, there's a pin holding it to the clutch pedal - en5 08:55:36 07/11/08 Pretty Simple - DualZ (SF) 09:01:07 07/11/08 Re: Pretty Simple - WazTTed 09:07:53 07/11/08 Not on TTs (n/m) - BigTDogg (MA) 09:35:03 07/11/08 This should have been in the tech section also (n/m) - DualZ (SF) 09:02:00 07/11/08 It's not too bad. - Z_Cherub 09:23:19 07/11/08 I have some pics here - robo (sebring1970) 12:40:40 07/11/08 Re: I have some pics here - WazTTed 23:49:55 07/12/08 I did not need to do any work inside the cabin to change - robo (sebring1970) 23:13:42 07/13/08
Post a Followup	You cannot reply to this message because you are not logged in.