Subject	I'd get the 300 degree fuel rails instead
Posted by	aliaZ on July 10, 2008 at 10:48 PM
	This message has been viewed 165 times.
In Reply To	Required machining for lower plenum? posted by Tibby on July 10, 2008 at 09:13 PM
Message	Some had had issues with the lower insulators splitting on the machined plenums
Follow Ups	Required machining for lower plenum? - Tibby 21:13:01 07/10/08 Re: Required machining for lower plenum? - awesom-o 21:16:53 07/10/08 I'd get the 300 degree fuel rails instead - aliaZ 22:48:35 07/10/08 I have the 95 rails already. - Tibby 08:58:20 07/11/08 To combat that, when I did my buildup, I made sure - pcproa 10:19:38 07/11/08 JWT will do it as a service for $100 plus postage. (n/m) - Bernie (NoVA) 01:39:53 07/11/08 That is $100 + postage more then it would cost me to do it - Tibby 09:04:22 07/11/08 I understand where you are coming from about saving $$$ - nonstopna 15:56:46 07/11/08 No offence taken, but I do not have the injectors... - Tibby 17:42:10 07/11/08 You don't need the injectors - you need the fuel rail. That' - Bernie (NoVA) 06:38:38 07/16/08
Post a Followup	You cannot reply to this message because you are not logged in.