Subject	Re: Required machining for lower plenum?
Posted by	awesom-o on July 10, 2008 at 9:16 PM
	This message has been viewed 153 times.
In Reply To	Required machining for lower plenum? posted by Tibby on July 10, 2008 at 09:13 PM
Message	I asked for this a couple years ago....no one had it (or would give it out if they did). Even called a few shops for the specs, I was told that they wouldn't give it to me because it would hurt their business. Good luck. White wheels are getting painted silver this winter.
Follow Ups	Required machining for lower plenum? - Tibby 21:13:01 07/10/08 Re: Required machining for lower plenum? - awesom-o 21:16:53 07/10/08 I'd get the 300 degree fuel rails instead - aliaZ 22:48:35 07/10/08 I have the 95 rails already. - Tibby 08:58:20 07/11/08 To combat that, when I did my buildup, I made sure - pcproa 10:19:38 07/11/08 JWT will do it as a service for $100 plus postage. (n/m) - Bernie (NoVA) 01:39:53 07/11/08 That is $100 + postage more then it would cost me to do it - Tibby 09:04:22 07/11/08 I understand where you are coming from about saving $$$ - nonstopna 15:56:46 07/11/08 No offence taken, but I do not have the injectors... - Tibby 17:42:10 07/11/08 You don't need the injectors - you need the fuel rail. That' - Bernie (NoVA) 06:38:38 07/16/08
Post a Followup	You cannot reply to this message because you are not logged in.