Subject	Re: Im getting irritated with installing the crankshaft seal!
Posted by	90coupeconversion on July 06, 2008 at 12:06 AM
	This message has been viewed 121 times.
In Reply To	Im getting irritated with installing the crankshaft seal! posted by turbo1 on July 05, 2008 at 01:54 PM
Message	The objective is to keep the seal square. If one side is higher that the other, the seal is not square on the crank, and will not last. Try to get it as even as possible all around.
Follow Ups	Im getting irritated with installing the crankshaft seal! - turbo1 13:54:56 07/05/08 Push it in like the other side (n/m) - doug8867 15:21:43 07/05/08 Re: Im getting irritated with installing the crankshaft seal! - 90coupeconversion 00:06:18 07/06/08 Get it flush (n/m) - Drk93TT 21:40:30 07/06/08 The best way is to use a short piece of PVC pipe to tap it - Audioquest 07:54:58 07/07/08 2nd on the PVC. Home Depot, electrical section -- get - jzack 20:25:53 07/07/08
Post a Followup	You cannot reply to this message because you are not logged in.