Subject	Im getting irritated with installing the crankshaft seal!
Posted by	turbo1 on July 05, 2008 at 1:54 PM
	This message has been viewed 136 times.
Message	So I went and installed my second seal, luckily nissan had one in stock. So this time I got it over the step, but one side got pushed in a mm more than flush and the otherside is flush. Would that work? Or should I push the flush side in just as far as the otherside?
Follow Ups	Im getting irritated with installing the crankshaft seal! - turbo1 13:54:56 07/05/08 Push it in like the other side (n/m) - doug8867 15:21:43 07/05/08 Re: Im getting irritated with installing the crankshaft seal! - 90coupeconversion 00:06:18 07/06/08 Get it flush (n/m) - Drk93TT 21:40:30 07/06/08 The best way is to use a short piece of PVC pipe to tap it - Audioquest 07:54:58 07/07/08 2nd on the PVC. Home Depot, electrical section -- get - jzack 20:25:53 07/07/08
Post a Followup	You cannot reply to this message because you are not logged in.