Subject	Here's what I used to install the front crankshaft seal...
Posted by	WoodmanZ on July 05, 2008 at 2:11 AM
	This message has been viewed 195 times.
In Reply To	Should I get a new crankshaft oil seal? posted by turbo1 on July 04, 2008 at 03:52 AM
Message	I cut a sierra mist bottle up and used the middle section to help get the seal over the step in the crankshaft. I oiled up the plastic and the seal, slid the seal right up to crankshaft, and used to pvc pipe fitting to evenly tap the seal into place.
Follow Ups	Should I get a new crankshaft oil seal? - turbo1 03:52:45 07/04/08 The safest thing to do... - zeeway 05:28:48 07/04/08 Agree on getting a new seal, but why do you assume he - ThunderZ 11:03:22 07/04/08 You are correct, I was changing the front seal. - turbo1 13:40:38 07/04/08 Use a short piece of PVC pipe the similar diameter - Audioquest 17:55:30 07/04/08 Putting in the bottom in 1st then sliding your thumbs - ThunderZ 21:29:03 07/04/08 Here's what I used to install the front crankshaft seal... - WoodmanZ 02:11:40 07/05/08
Post a Followup	You cannot reply to this message because you are not logged in.