Subject	Re: The way I did it:
Posted by	not scared on July 03, 2008 at 12:46 AM
	This message has been viewed 142 times.
In Reply To	The way I did it: posted by escturbo on July 02, 2008 at 08:49 PM
Message	ok, im under the impression that you drilled that hole in the flat bracket that the sliding rail is bolted to? that bracket seems to be much stronger than the slide rail itself. i looked at the rail, and the seat looking at how it would be mounted, and i noticed that to attach the seat i have to remove the slider from the base bracket, and thus i noticed it was a somewhat universal slider mounted on a bracket made for the z32. i just want to clarify before i go driling a hole in the wrong location. thank you for your input, i will also contact charles about his method.
Follow Ups	corbeau seat factory seat belt - not scared 18:38:56 07/02/08 The way I did it: - escturbo 20:49:39 07/02/08 Re: The way I did it: - not scared 00:46:26 07/03/08 Yes, I worded it wrong... - escturbo 04:16:54 07/03/08 Re: Yes, I worded it wrong... - not scared 14:55:08 07/04/08 Welding is permanent & not recommended... - escturbo 17:44:42 07/04/08
Post a Followup	You cannot reply to this message because you are not logged in.