Subject	Yea that was the first thing i did.
Posted by	redfarsi on July 03, 2008 at 12:36 AM
	This message has been viewed 149 times.
In Reply To	and make sure to cut your wires to different lengths posted by vorpalZ on July 02, 2008 at 10:59 AM
Message	That's an obvious one but thanks for the reminder anyways. I'm almost done except two of the screws holding down the injector caps are completely messed up becuase of last years f*cking around. I'll probably use a power drill for those.(I already dremeled the plenum, just gotta remove the screws and swap the injectors.) Thanks for the help guys I'll post if I got another question so far it's all going smooth.
Follow Ups	Injector connect splicing - redfarsi 20:49:58 07/01/08 Injectors are NOT polarity sensitive -- they don't care - jzack 21:39:21 07/01/08 Awesome, thanks a lot jzack! (n/m) - redfarsi 21:54:57 07/01/08 I would do skinny to skinny - RedTTZ91(OK) 23:05:00 07/01/08 There is no skinny to skinny, or fat to fat. (n/m) - redfarsi 23:20:10 07/01/08 It must depend on the model then, because mine did. (n/m) - Jinjiro 10:30:54 07/02/08 No - the issue is the connectors that he got have same - Bernie (NoVA) 17:18:41 07/02/08 FYI -- This FAQ gives some tips on good ways to seal - jzack 23:17:58 07/01/08 and make sure to cut your wires to different lengths - vorpalZ 10:59:03 07/02/08 Yea that was the first thing i did. - redfarsi 00:36:06 07/03/08 Needle nose vice grips work well for removing fubared - doug8867 11:11:43 07/03/08
Post a Followup	You cannot reply to this message because you are not logged in.