Subject	Installed injectors for the first time...
Posted by	scottyfender on July 02, 2008 at 4:51 PM
	This message has been viewed 179 times.
Message	Just to make sure, I could not push the injector all the way it. I had to screw the cap on to push the injectors in. Is that normal? "Well I have an ex-wife, a girlfriend with 2 kids, 4 kids of my own, a boss and, a mother. I don't have any more room for making people happy." "She's always wet and hot and purrs when I slide inside of her. She screams when I put my foot down and isn't too hard to control. She is usually straight but she slides her rear out when I ask her too. Always gives me a boost. Stays with me and leaves the other guys behind. She is even more fun when her top is off...so free. Sometimes a friend will join in, male or female, and we both enjoy her. Plus she is a non smoker...what more can you ask for?"
Follow Ups	Installed injectors for the first time... - scottyfender 16:51:36 07/02/08 Yes, sir. BUT -> - Milo (SATX) 17:05:35 07/02/08 Did that and used motor oil. it didn't bind up. went smooth (n/m) - scottyfender 17:15:45 07/02/08 3rd - Lubed everthing up well with petro jelly and pressed - jzack 20:43:08 07/02/08 no. The injector should seat all the way down. You don't - Guapo 18:03:54 07/02/08 Ok 2 different answers from 2 reputable people... - scottyfender 19:16:14 07/02/08 if they went in smooth then you are prob okay. I have - robo (sebring1970) 22:16:25 07/02/08 agreed with robo that you're probably okay if they went in - Guapo 09:20:45 07/03/08 2nded. don't use the cap - AntiHero 09:21:50 07/03/08 Suggestion after install - Z-Tech 20:27:25 07/02/08 I pressured up the rail and it held air. - scottyfender 22:12:02 07/03/08
Post a Followup	You cannot reply to this message because you are not logged in.