Subject	Custom Dual pop setup question
Posted by	Shorebreak on July 02, 2008 at 2:05 AM
	This message has been viewed 234 times.
Message	I recently got everything ready to set a custom dual pop setup; however, I noticed that the 120 degree mandrel bent elbows that I cut were having trouble fitting. I think cutting the pipes shorter may help the fit, but I was wondering if my 120 degree bends are too wide. Also, is it normal for the filters on this type of setup to hang well below the bumper reinforcement?
Follow Ups	Custom Dual pop setup question - Shorebreak 02:05:17 07/02/08 JWT Dual Pops that I have installed do not hang that low. - Bernie (NoVA) 17:17:22 07/02/08 Re: JWT Dual Pops that I have installed do not hang that low - WazTTed 04:25:55 07/05/08
Post a Followup	You cannot reply to this message because you are not logged in.