Subject	Re: Engine assembly/break-in lube
Posted by	eyagel (Houston) on June 28, 2008 at 12:01 AM
	This message has been viewed 559 times.
In Reply To	Engine assembly/break-in lube posted by J-Mart on June 27, 2008 at 12:05 PM
Message	controversial, i have heard a story of a slight bit of surface rust on a rod bearing on a crank, installed that way and then almost on startup, it was knocking. call the machine shop and see if u can steal some of their stuff.
Follow Ups	Engine assembly/break-in lube - J-Mart 12:05:29 06/27/08 my machinist told me to wd40 every couple weeks since - TheSlimOne 15:04:31 06/27/08 Re: Engine assembly/break-in lube - eyagel (Houston) 00:01:38 06/28/08 best to install asap but - Dane (Houston) 03:42:57 06/28/08 WD40 Seems to do a good job - Bezza 17:11:06 06/28/08
Post a Followup	You cannot reply to this message because you are not logged in.