Subject	Try removing your crank angle sensor and then put it back
Posted by	doug8867 on June 26, 2008 at 8:13 PM
	This message has been viewed 258 times.
In Reply To	Re: (in addition to) Timing belt fiasco.... posted by puddlejumpinzx on June 25, 2008 at 11:20 PM
Message	Since the cam gears are keyed I think it would pretty hard to not get them lined back up properly and can't think why your ptu would crap out so that leaves a misaligned CAS. Perhaps you don't have that little half moon pin fully inserted? Grasping at straws...
Follow Ups	Timing belt fiasco.... - puddlejumpinzx 19:50:59 06/25/08 Re: Timing belt fiasco.... - txq45 20:27:16 06/25/08 Yeah, and check for corrosion on cas connector (n/m) - jlag 21:02:10 06/25/08 1/2 a tooth out? Why, all you have to do is line up the gear - Audioquest 22:24:39 06/25/08 it is not possible to be a half a tooth off (n/m) - aliaZ 22:34:36 06/25/08 Re: (in addition to) Timing belt fiasco.... - puddlejumpinzx 23:20:07 06/25/08 Try removing your crank angle sensor and then put it back - doug8867 20:13:13 06/26/08 I don't see how the belt is related to you problem. (n/m) - Bernie (NoVA) 01:39:39 06/26/08 Re: I don't see how the belt is related to you problem. - puddlejumpinzx 11:18:50 06/26/08 Only thing I could guess that would relate the issues - Audioquest 11:22:19 06/26/08 Re: Only thing I could guess that would relate the issues - puddlejumpinzx 13:59:07 06/26/08 Re: Re: One more thing... - puddlejumpinzx 14:01:55 06/26/08 I am not familiar with the resistor you are talking of but - Audioquest 07:57:40 06/27/08 Re: Timing belt fiasco.... - puddlejumpinzx 00:32:09 06/27/08 Electrical contact cleaner and a pic work great for removing - doug8867 07:46:28 06/27/08 Good for you. The #1 cause of poor running. Pull all - Audioquest 08:53:39 06/27/08
Post a Followup	You cannot reply to this message because you are not logged in.