TwinTurbo.NET: Nissan 300ZX forum - Use a jumper wire to connect the 2 sides together on the
Subject
Use a jumper wire to connect the 2 sides together on the
Posted by
WoodmanZ
on June 25, 2008 at 7:23 PM
This message has been viewed
193
times.
In Reply To
Re: Re: bypassing the neutral safety switch?
posted by John B
on June 25, 2008 at 07:06 PM
Message
clutch pedal safety switch. If the car still doesn't start after that there is another safety switch on the transmission. Ground this one by jumping the green/yellow wire straight to the ground at one of the tranny mounts.
Follow Ups
car won't start - advice?
-
John B
12:32:05 06/25/08
Just bc the battery shows strong voltage doesn't mean
-
300ZMang
12:46:53 06/25/08
2nd. check my post above, similar issue >>
-
stockplayerz(nyc)
23:47:11 06/29/08
12.8 is not low...12.65 is considered "perfect"
-
BobbyT
14:35:21 06/25/08
Have you checked the small solenoid wire
-
Audioquest
16:36:32 06/25/08
Have you tried bypassing the neutral safety switch?? Is the
-
WoodmanZ
16:39:43 06/25/08
Re: Have you tried bypassing the neutral safety switch?? Is the (n/m)
-
John B
18:59:34 06/25/08
Re: Re: bypassing the neutral safety switch?
-
John B
19:06:22 06/25/08
Use a jumper wire to connect the 2 sides together on the -
WoodmanZ
19:23:34 06/25/08
Re: Re: bypassing the neutral safety switch?
-
John B
19:52:03 06/25/08
Post a
Followup
You cannot reply to this message because you are not
logged in
.