Subject	Tap all holes before putting a bolt in them, especially with
Posted by	zellamay on June 22, 2008 at 10:17 AM
	This message has been viewed 130 times.
In Reply To	What to do, my precious BLOCK, Woooe is me posted by Gokussayien on June 22, 2008 at 08:07 AM
Message	any used parts. Any little piece of s*** with mess with your torque specs. And put a little oil on the bolt, to make sure it doesn't gall going in. This is standard practice in a good machine shop.......... If you take the RPG option, remove the car from your garage first.
Follow Ups	What to do, my precious BLOCK, Woooe is me - Gokussayien 08:07:58 06/22/08 Re: What to do, my precious BLOCK, Woooe is me - txq45 08:37:01 06/22/08 2nd on letting a machine shop do it - na300zx (OH) 08:41:02 06/22/08 Did you put the short bolt in the wrong hole? - na300zx (OH) 08:37:56 06/22/08 2nd that. (n/m) - Devi13 13:28:52 06/22/08 Re: Did you put the short bolt in the wrong hole? - Gokussayien 15:08:48 06/22/08 *one shorter bolt (n/m) - na300zx (OH) 19:13:43 06/22/08 Tap all holes before putting a bolt in them, especially with - zellamay 10:17:39 06/22/08 Do not use a tap to clean the threads - ZXRider(SoCal) 11:54:26 06/22/08 Re: Do not use a tap to clean the threads - Gokussayien 15:16:02 06/22/08
Post a Followup	You cannot reply to this message because you are not logged in.