Subject	Before I track down JWTs number, I'll ask you
Posted by	na300zx (OH) on June 19, 2008 at 5:07 AM
	This message has been viewed 122 times.
In Reply To	No special machining with any of the single valve springs posted by LitlElvis on June 18, 2008 at 04:10 PM
Message	Do you know what the seat pressure is supposed to be on a set of JWT springs? They didn't come with any specs other than "chamfered side up". If there is no spec, what do you set it to? Thanks.
Follow Ups	quick JWT cam question... - won4all 16:03:43 06/18/08 No special machining with any of the single valve springs - LitlElvis 16:10:23 06/18/08 Heads are getting a full port (n/m) - won4all 16:15:27 06/18/08 Before I track down JWTs number, I'll ask you - na300zx (OH) 05:07:59 06/19/08 I believe it's in the 75 lb range at 35mm installed height (n/m) - LitlElvis 06:28:24 06/19/08 Thanks a bunch! (n/m) - na300zx (OH) 15:54:57 06/19/08
Post a Followup	You cannot reply to this message because you are not logged in.