Subject	New det. sensor, sub-harness, EFI harness, ECU, same code34
Posted by	FuerGrissa on June 17, 2008 at 11:46 AM
	This message has been viewed 345 times.
Message	Please verify that I have this hooked up right? The middle clip was connected to the disconnected clip to the right of it (the yellowish and black wires), this is now hooked up to the det sensor (relocated right under the middle clip in picture). The clip on bottom in the picture with the 3 wires and white sheath is connected to the driver's side O2 sensor. The clip on the left is square shaped and wasn't hooked to anything, I don't know what it is for. Is this all right?
Follow Ups	New det. sensor, sub-harness, EFI harness, ECU, same code34 - FuerGrissa 11:46:17 06/17/08 No, wrong harness. - Woody75 (Denver) 12:29:14 06/17/08 I found the harness - FuerGrissa 13:22:17 06/17/08 That's the VTC harness...plug it in to where your DET sensor - twinturbineZ 13:28:26 06/17/08 Code 34 GONE, new problem... - FuerGrissa 13:54:41 06/17/08 Where did you plug the 02 harness into..pic please (n/m) - twinturbineZ 13:57:44 06/17/08 as requested (doh preview'ed and forgot to post) - FuerGrissa 14:24:02 06/17/08 your labelling appears correct (n/m) - Guapo 14:35:22 06/17/08 The part I have labled as "IAVC?" FSM says "air regulator" - FuerGrissa 14:41:05 06/17/08 yeah, I can't remember all the acronyms, but it is the - Guapo 14:58:06 06/17/08 The plugs were replaced about a month ago - FuerGrissa 15:21:32 06/17/08 NVM I'll still check the plugs but - FuerGrissa 15:32:54 06/17/08 well ... if it comes back, run codes again (n/m) - Guapo 15:55:32 06/17/08 I found the harness, revision 1 - FuerGrissa 13:25:35 06/17/08 There should be another group of plugs over toward the - twinturbineZ 12:56:41 06/17/08
Post a Followup	You cannot reply to this message because you are not logged in.