Subject	I never heard of someone putting a z over .o40 over (n/m)
Posted by	RedTTZ91(OK) on June 13, 2008 at 8:56 PM
	This message has been viewed 160 times.
In Reply To	I've heard of .040 over and .075 over, dont know the posted by amp300zx on June 13, 2008 at 05:14 PM
Message
Follow Ups	Stupid Question - amp300zx 16:45:46 06/13/08 Who built it? What comes with it? What are you paying for - zellamay 17:04:58 06/13/08 Re: Who built it? What comes with it? What are you paying - amp300zx 17:12:59 06/13/08 Here's something else to consider...... - twinturbineZ 18:08:27 06/13/08 Isn't .075 over kind of a lot? - FuerGrissa 17:13:08 06/13/08 I've heard of .040 over and .075 over, dont know the - amp300zx 17:14:58 06/13/08 I never heard of someone putting a z over .o40 over (n/m) - RedTTZ91(OK) 20:56:05 06/13/08 Im starting to think it was a typo - amp300zx 21:22:59 06/13/08 87.5 mm = .020" over - na300zx (OH) 09:21:37 06/14/08 Well the compression is custom, maybe the piston size is too - amp300zx 22:39:58 06/14/08 I've been running 89mm pistons with no problems - itsghoZt 11:39:44 06/14/08 Just found out - amp300zx 15:43:27 06/16/08
Post a Followup	You cannot reply to this message because you are not logged in.