Subject	Did Resistor bypass with knock sensor, worked for a while
Posted by	Red300zxTT on June 12, 2008 at 4:33 PM
	This message has been viewed 652 times.
Message	then stopped. I went to radio Shack and bought a pack of resistors 1-Megohm Resistors. 1/2 watt. 5% tolerance. It worked for about 3 miles. Then I drove to burger-king and parked came back out and it was faulty again. I dunno why this happened. Did i buy the right resistors are they strong enough? Or is it just because I didn't sodder it into the lines? Thanks Greatly would appreciate your help, going out wit the boys tonight and safety boost is no fun.
Follow Ups	Did Resistor bypass with knock sensor, worked for a while - Red300zxTT 16:33:16 06/12/08 maybe you have a fault in your harness? (n/m) - aliaZ 16:52:48 06/12/08 Soo i should trace the wire back to the ecu. - Red300zxTT 16:54:35 06/12/08 Or just check the wiring within a few inches of the - jzack 18:47:09 06/12/08 I traced it back a couple of inches from the connector - Red300zxTT 20:04:22 06/12/08 Buzzing the lines out for continuity would be the next - jzack 23:13:30 06/12/08 why not just fix it the correct way? (n/m) - eyagel 19:41:46 06/12/08 I agree! However...how did you connect the resistor - twinturbineZ 20:34:25 06/12/08 On my connector I have three slots. I put the resistor - Red300zxTT 01:05:31 06/13/08 there should only be 2 slots on that connector - cossiemodo2000 02:50:16 06/13/08 3slots... with red, black and white wires ? - Dark Diver 06:19:34 06/13/08 That's correct! (n/m) - twinturbineZ 06:53:51 06/13/08 The resistor goes across the white and gray wires! (n/m) - twinturbineZ 06:54:36 06/13/08 KK kool thanks man! (n/m) - Red300zxTT 10:59:16 06/13/08
Post a Followup	You cannot reply to this message because you are not logged in.