Subject	Kinda tough to tell, don't ya think? It could be the slave
Posted by	ThunderZ on June 09, 2008 at 5:50 PM
	This message has been viewed 74 times.
In Reply To	Likely your master cylinder needs replacing (n/m) posted by Audioquest on June 09, 2008 at 01:11 PM
Message	or a broken pressure plate, or a broken fork... You can get it home. Start the engine in 1st gear, hit the gas, and drive it home. IIRC, you can shift 1-2 at 12 mph and 2-3 at 28 mph. Must do an inspection, starting with what doug8867 says. Z_Cherub, hope your Dad's OK, man.
Follow Ups	Hey all. - Z_Cherub 12:10:13 06/09/08 No suggestions, but hope things work out for you with... - Marc (NJ) 13:07:12 06/09/08 Thanks, man. I appreciate it... - Z_Cherub 13:41:54 06/09/08 Likely your master cylinder needs replacing (n/m) - Audioquest 13:11:48 06/09/08 That's what I was afraid of... Thanks for the input. - Z_Cherub 13:44:16 06/09/08 Kinda tough to tell, don't ya think? It could be the slave - ThunderZ 17:50:32 06/09/08 Thanks, Oliver. All good points. - Z_Cherub 22:24:14 06/09/08 Helping someone on line is not always 100%, but - Audioquest 08:20:34 06/10/08 I'll check that out... Thanks again!! (n/m) - Z_Cherub 09:04:55 06/10/08 2nd. (n/m) - ForceFedTT 00:34:31 06/11/08 Have someone push the clutch in while you look under - doug8867 17:28:13 06/09/08 Good call. I'll have to give that a shot tomorrow. - Z_Cherub 22:26:49 06/09/08 Where are you? Maybe someone nearby on the forum - jzack 18:10:10 06/09/08 Good point. Honestly, I've had so much other stuff - Z_Cherub 22:35:26 06/09/08 How's your Father doing? (n/m) - Marc (NJ) 14:29:00 06/10/08 A bit better, thanks for asking! - Z_Cherub 15:35:10 06/10/08
Post a Followup	You cannot reply to this message because you are not logged in.