Subject	You should be able to do it...
Posted by	dyno 500 HP 300ZXTT on June 09, 2008 at 4:13 AM
	This message has been viewed 165 times.
In Reply To	Plenum pull, PCV valve(s) replacement, and valve cover gaske posted by CaptainZappo on June 08, 2008 at 11:35 PM
Message	Just remember and label things so you know where everything goes when you put back together. The hardest part is going to be the little hoses/connectors on the side/kind of under the plenum. Make sure you have long term memory or a tip is use a digital camera to take pictures for reference of where things go.
Follow Ups	Plenum pull, PCV valve(s) replacement, and valve cover gaske - CaptainZappo 23:35:40 06/08/08 only you can answer that.... (n/m) - twinturbineZ 23:55:05 06/08/08 If the Z is not your DD - ZXRider(SoCal) 02:27:16 06/09/08 You should be able to do it... - dyno 500 HP 300ZXTT 04:13:31 06/09/08 Just be aware you will most likely have to replace some - Audioquest 11:02:56 06/09/08 What color was the smoke? - doug8867 12:45:09 06/09/08 This job isn't real hard but there can be a lot to deal - jzack 18:20:56 06/09/08 thanks for all the suggestions! - CaptainZappo 01:06:57 06/10/08
Post a Followup	You cannot reply to this message because you are not logged in.