Subject	HubCentric Rings
Posted by	sandplasma on June 07, 2008 at 11:13 AM
	This message has been viewed 147 times.
Message	I have an aftermarket set of wheels with the following specifications: Front: 18x8.5 ET25 HB 73 Rear: 18x9.5 ET28 HB 67.1 I know that the Hub Bore for the Z32 is 66mm..and the fronts did come with a hubcentric rings that make them 67.1mm as well. Would it be ok if I used the 67.1 rings and installed the wheels on the car? Or is that small difference of 1.1mm going to still cause vibrations? Thanks guys.
Follow Ups	HubCentric Rings - sandplasma 11:13:46 06/07/08 You should be fine (n/m) - twinturbineZ 15:58:24 06/07/08
Post a Followup	You cannot reply to this message because you are not logged in.