Subject	Re: check the center or middle wire on the coil connector
Posted by	puddlejumpinzx on June 07, 2008 at 1:55 AM
	This message has been viewed 84 times.
In Reply To	check the center or middle wire on the coil connector posted by twinturbineZ on June 06, 2008 at 11:03 PM
Message	I'm not getting any spark, or any voltage at the center wire on the 7 pin connector at the PTU and all fuses are good. The only thing left is the ECU which, as stated earlier, was chipped by Ash. I'm not trying to talk bad about the guy or his services but it could be my problem.
Follow Ups	Z won't start... - puddlejumpinzx 18:09:25 06/06/08 Did you plug in the temp sensors...and MAF? (n/m) - twinturbineZ 18:29:00 06/06/08 Re: Did you plug in the temp sensors...and MAF? - puddlejumpinzx 18:36:11 06/06/08 Check the PTU..is there spark..fuel..getting to - twinturbineZ 19:19:44 06/06/08 are you pulling any codes?? (n/m) - twinturbineZ 19:25:40 06/06/08 Re: are you pulling any codes?? - puddlejumpinzx 19:56:14 06/06/08 RShouldn't be..however..just check the CAS connection - twinturbineZ 20:48:14 06/06/08 Re: RShouldn't be..however..just check the CAS connection - puddlejumpinzx 21:08:15 06/06/08 check the center or middle wire on the coil connector - twinturbineZ 23:03:20 06/06/08 Re: check the center or middle wire on the coil connector - puddlejumpinzx 01:55:39 06/07/08 That's not what I told you to do! I said...check - twinturbineZ 15:45:44 06/07/08 clean the CAS and PTU connectors, especially the CAS - fanta-z 12:01:24 06/07/08
Post a Followup	You cannot reply to this message because you are not logged in.