Subject	RShouldn't be..however..just check the CAS connection
Posted by	twinturbineZ on June 06, 2008 at 8:48 PM
	This message has been viewed 77 times.
In Reply To	Re: are you pulling any codes?? posted by puddlejumpinzx on June 06, 2008 at 07:56 PM
Message	to be sure..it could be loose..corroded...Also check the PTU connections for the same thing... So I'm having this dream! I'm in my Z and these guys are after me, but they can't catch me...So they get a car, but they still can't catch me. So they get a plane, and just as their about to catch me....the TWIN TURBOS KICK IN!
Follow Ups	Z won't start... - puddlejumpinzx 18:09:25 06/06/08 Did you plug in the temp sensors...and MAF? (n/m) - twinturbineZ 18:29:00 06/06/08 Re: Did you plug in the temp sensors...and MAF? - puddlejumpinzx 18:36:11 06/06/08 Check the PTU..is there spark..fuel..getting to - twinturbineZ 19:19:44 06/06/08 are you pulling any codes?? (n/m) - twinturbineZ 19:25:40 06/06/08 Re: are you pulling any codes?? - puddlejumpinzx 19:56:14 06/06/08 RShouldn't be..however..just check the CAS connection - twinturbineZ 20:48:14 06/06/08 Re: RShouldn't be..however..just check the CAS connection - puddlejumpinzx 21:08:15 06/06/08 check the center or middle wire on the coil connector - twinturbineZ 23:03:20 06/06/08 Re: check the center or middle wire on the coil connector - puddlejumpinzx 01:55:39 06/07/08 That's not what I told you to do! I said...check - twinturbineZ 15:45:44 06/07/08 clean the CAS and PTU connectors, especially the CAS - fanta-z 12:01:24 06/07/08
Post a Followup	You cannot reply to this message because you are not logged in.