Subject	Sorry no pic, but the line attaches to the slave cylinder
Posted by	doug8867 on June 04, 2008 at 7:32 AM
	This message has been viewed 139 times.
In Reply To	could someone post a picture where the this goes--->>> posted by DKaway on June 04, 2008 at 05:16 AM
Message	under the car on the driver's side of the engine/transmission and replaces the stock rubber hose. The other end attaches to the clutch hardline that leads up to the engine bay and has a bleed point near the passenger side shock. The slave cylinder (aka. operating cylinder in your service manual) is a little cylindrical device about that is attached to the underside of your engine with two bolts. Hope that helps.
Follow Ups	could someone post a picture where the this goes--->>> - DKaway 05:16:51 06/04/08 Sorry no pic, but the line attaches to the slave cylinder - doug8867 07:32:10 06/04/08 yes it helps, but a nother question--->>> - DKaway 13:33:38 06/04/08 Unless you are converting to a 5-spd from an AT just the - doug8867 15:54:17 06/04/08 great thanks for your help. Z on! (n/m) - DKaway 17:39:03 06/04/08 Just get the full length - ZDUCTIV 09:48:23 06/05/08
Post a Followup	You cannot reply to this message because you are not logged in.