Subject	?????
Posted by	Insomniac (VA) on June 03, 2008 at 11:02 AM
	This message has been viewed 130 times.
In Reply To	heat with a blow dryer to soften the urethane posted by ZEngineer on June 03, 2008 at 10:38 AM
Message	I don't think that's what he was asking, lol. Try heating them up in an oven with the door slightly open. I wanna say 250-300, and only for a few minutes to heat them up enough you can gently pry the lens apart from the back going evenly all the way around with either your fingers or a wooden...spatula or something so you don't crack the plastic. And only lift a little at a time.
Follow Ups	So what's the best way to remove the lens from the tails? - ZLover4Life 10:26:37 06/03/08 heat with a blow dryer to soften the urethane - ZEngineer 10:38:40 06/03/08 ????? - Insomniac (VA) 11:02:38 06/03/08 you're right - ZEngineer 11:47:46 06/03/08 Yea - Insomniac (VA) 12:07:12 06/03/08 thanks guys - ZLover4Life 12:23:18 06/03/08 putting it on a tray instead of on the hot rack would spread - gt300zxtt 12:47:24 06/03/08 I propped mine in the door - awesom-o 13:14:21 06/03/08 you noobs! - spicyZ 13:14:10 06/03/08
Post a Followup	You cannot reply to this message because you are not logged in.