Subject	Oooops, #7 on the list....
Posted by	LitlElvis on March 08, 2008 at 11:31 AM
	This message has been viewed 300 times.
In Reply To	Refer to the service manual for installing cams posted by LitlElvis on March 08, 2008 at 11:20 AM
Message	7) Use the hex (1" or ~25mm) that is cast into the camshafts to hold them from rotating when loosening or torquing the sprocket bolts.
Follow Ups	Is there a write up on Jim Wolf 500 cams installation? (n/m) - jmurcybizd 23:18:40 03/07/08 I've been told it should only be done by the experienced - J-Mart 23:44:51 03/07/08 While we are on the subject... - J-Mart 23:58:33 03/07/08 Dual coil springs are stronger, but they also stress the cam - na300zx (OH) 04:17:35 03/08/08 If I go with JUN adjustable cam gears - J-Mart 10:18:49 03/08/08 Re: If I go with JUN adjustable cam gears - txq45 10:44:45 03/08/08 What is the function of the VTC Spring? - J-Mart 11:22:38 03/08/08 I just love VTC related questions... - LitlElvis 11:47:11 03/08/08 Hurry up and get yours ready :) (n/m) - na300zx (OH) 15:35:09 03/08/08 heh (n/m) - aliaZ 17:19:20 03/08/08 Re: Is there a write up on Jim Wolf 500 cams installation? ( - txq45 10:12:21 03/08/08 Re: Re: Is there a write up on Jim Wolf 500 cams installation? ( - plower 08:42:41 03/09/08 Refer to the service manual for installing cams - LitlElvis 11:20:59 03/08/08 Oooops, #7 on the list.... - LitlElvis 11:31:09 03/08/08 I'll add a #8 - don't put on the valve covers until you - boileralum 19:16:22 03/08/08 very usefull info thanks to all!! (n/m) - jmurcybizd 23:53:27 03/08/08 I'll add , check valve timing via degree wheel , dial - AZHeat 04:08:27 03/09/08 Yep I see about +-0.5 deg from the slop when setting them up (n/m) - LitlElvis 12:41:54 03/09/08
Post a Followup	You cannot reply to this message because you are not logged in.