TwinTurbo.NET: Nissan 300ZX forum - You said you replaced the connectors. Get a schematic..
People Seeking Info
 
   


     
Subject You said you replaced the connectors. Get a schematic..
     
Posted by Sleeper_TTZ on April 04, 2007 at 3:17 AM
  This message has been viewed 56 times.
     
In Reply To What about an ohm test? posted by cjm300zxtt on April 03, 2007 at 10:55 PM
     
Message and make sure you didn't cross any wires. If there's discoloration to the post and the plastic around, then there is a short in the curcit. And it doesn't have a good ground or there is to much current trying to pass through the curcit. I would investigate the wiring harness and or ecu to make sure your not burning them out due to over loading or in adequate grounding some how.

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.