TwinTurbo.NET: Nissan 300ZX forum - Probably obvious, but after 20 min. of trying to get the
Subject
Probably obvious, but after 20 min. of trying to get the
Posted by
BummedOutMonkey
on October 04, 2006 at 9:26 AM
This message has been viewed
171
times.
In Reply To
clutch replacement...pic heavy
posted by naZeer (Dallas)
on October 04, 2006 at 08:38 AM
Message
transmission stabbed in, I just made sure that the gap was exactly the same all the way around the housing (about 1"). Once it was perfect (with my finger measuring system) it fell in instantly.
Follow Ups
clutch replacement...pic heavy
-
naZeer (Dallas)
08:38:34 10/04/06
Nice writeup. Thanks (n/m)
-
zzman (nashville)
08:52:58 10/04/06
great writeup w/ pics and tips
-
bobZtwin (NC)
09:01:48 10/04/06
Nice job!, that's a sexy car you got there (n/m)
-
BigTDogg (MA)
09:07:44 10/04/06
Great post!
-
vorpalZ
09:15:09 10/04/06
good writeup - bookmarked (n/m)
-
spicyZ
09:22:17 10/04/06
Fantastic work! I'm loving the 3 inch bolt trick. (n/m)
-
Zeus
09:22:56 10/04/06
2nd - wish I knew about that a while back! (n/m)
-
TT XTZ
09:25:25 10/04/06
Excellent write-up
-
TT XTZ
09:24:59 10/04/06
Probably obvious, but after 20 min. of trying to get the -
BummedOutMonkey
09:26:27 10/04/06
Nice writeup!
-
Mickie
09:40:37 10/04/06
Great write-up! I wish I'd known about using
-
Dustin
09:54:37 10/04/06
Nice post! Another safety tip when using that style of
-
Inzane
09:55:31 10/04/06
whoa! check you out.
-
LordZ
10:45:12 10/04/06
awesome! i need that tranny jack.
-
apudapus
11:42:32 10/04/06
Nice! (n/m)
-
mousersix
12:29:08 10/04/06
OK - question about dropping the exhaust...
-
jzack
16:54:09 10/04/06
cut what???
-
LordZ
17:14:50 10/04/06
Dosen't work so well on a 2+2 , has two hangers in the
-
jzack
22:22:28 10/04/06
I put the stock ones on and took off 3 times so far
-
LordZ
20:33:01 10/05/06
thanks for the compliments guys...
-
naZeer (Dallas)
20:01:43 10/04/06
very good tip, learned this the hard way (n/m)
-
mousersix
21:35:43 10/04/06
damn, wow
-
PakiHomBoy
17:17:33 10/04/06
Awesome job. Do you happen to have the part # to
-
Worm Boy
21:43:32 10/04/06
throw out bearing 30502-45P00
-
naZeer (Dallas)
23:26:48 10/04/06
Post a
Followup
You cannot reply to this message because you are not
logged in
.