Subject	Re: Thread size/pitch for stock Oil Pressure Sending Unit?
Posted by	aace73 on September 01, 2006 at 7:17 PM
	This message has been viewed 468 times.
In Reply To	Thread size/pitch for stock Oil Pressure Sending Unit? posted by amorak on September 01, 2006 at 01:32 AM
Message	: :Since the JDM oil pressure sending unit is pretty much unreachable, I am going to do the next best thing: Install an aftermarket gauge! :Because the JDM sending unit is on the other side of the block, apparently the stock North American location is avaialbe, with just a bolt blocknig it off. So I am thinking I will tee into there - What's the size/pitch of that hole? :Thanks! Let me know how that works out I need to do the same thing. Man who stands on toilet is high on pot!!!!
Follow Ups	Thread size/pitch for stock Oil Pressure Sending Unit? - amorak 01:32:51 09/01/06 1/8 bspt - Tuppidsay 14:37:37 09/01/06 Re: Thread size/pitch for stock Oil Pressure Sending Unit? - aace73 19:17:31 09/01/06 what? its easy to get too.. I just swapped the plug/sender - musky 22:05:18 09/01/06
Post a Followup	You cannot reply to this message because you are not logged in.