TwinTurbo.NET: Nissan 300ZX forum - Will this idea work?
People Seeking Info
 
   


     
Subject Will this idea work?
     
Posted by Woody75 (Denver) on September 30, 2002 at 9:54 AM
  This message has been viewed 246 times.
     
In Reply To PCV system reroute - no more burning oil! WooHoo! posted by AshsZ (Fab Whore, Ph.D) on September 30, 2002 at 08:29 AM
     
Message I think it's same thing they did on the SCC Z. Plug the 2 drivers side valve cover pipes or connect them like you did only minus the filter. Then tap into the high point of both the valve covers that sits about in the middle of the plenum when installed. Run lines from there back and around to the PCV valve. I would be using the high point of the valve cover but the system basically stays the same.

I'm sure you looked into this as well. Whats your thoughts on it?

JackB nimble JackB quick JackB can suck my dick =P (n/m) - james-lee 19:14:33 11/02/01
Arrogance is the #1 weapon against Supra Owners (n/m) - MikeH(Twin GT35BB Incon Z) 08/06/02

     
Follow Ups  
     
Post a
Followup

You cannot reply to this message because you are not logged in.