| 1 - The two M6 (?) studs that came pre-installed into the wing for fastening the two back corners were kind of poorly aligned and I couldn't get them to work. I removed them, aligned and taped down the wings, then epoxied in m5 studs with West Systems epoxy + filler in locations that worked for me. I used M5 so that I could use factory nuts and caps from my OEM NA TBL. 2 - The TT TBL did not fit well into the recess. I had to do a good amount of sanding and blending with a dremel sanding drum to get it to fit and have clearance for paint. 3 - Fitment to the shape of the hatch was pretty good. Really didn't have to massage much there. 4 - The leading edge of the wing has a molded in recess that looks like it's intended for trip adhesive tape, but it didn't work well for me. The depth was variable and the tape was either too thick for the groove or the groove was too deep and the tape wouldn't bridge between the spoiler and hatch. I ended up gluing it down with grey urethane adhesive. 5 - I did not use the two tapped holes on the front corners for mounting, just the urethane adhesive and the two rear studs
|
