Subject	I was just saying that IF you really wanted to see the temp
Posted by	Woodnutz (PA) on January 08, 2025 at 12:04 PM
	This message has been viewed 13 times.
In Reply To	More than likely, it's in the plenum, either in the EGR port posted by Woodnutz (PA) on January 07, 2025 at 11:33 AM
Message	drop, you could get all those measurements. It's just to determine the actual performance of the intercooler system. As far as Haltech control goes, the idea is to know the air temp just prior to ignition, for appropriate fueling. This is why they say to put the IAT as close to the valves as possible (which ends up being on the plenum somewhere, typically). - Aaron
Follow Ups	SZ IC temperature drop demo - sasha 21:39:01 01/03/25 Re: SZ IC temperature drop demo - Mike@ZSpeed 22:25:47 01/03/25 I assume that's manifold air temp from your MAP sensor? - black300zx 10:30:58 01/04/25 I don't know exactly where the sensor is located. - sasha 16:41:41 01/04/25 More than likely, it's in the plenum, either in the EGR port - Woodnutz (PA) 11:33:27 01/07/25 Makes sense - sasha 13:00:26 01/07/25 I was just saying that IF you really wanted to see the temp - Woodnutz (PA) 12:04:56 01/08/25
Post a Followup	You cannot reply to this message because you are not logged in.